Mobirise

371131
Placa de Inducción de 2 secciones, control individual, diam. 230 mm

371131 (E7INED200N)

2 zone hot plate electric induction cooking top range - 230V

Volver a gama 700XP


  • 6 mm thick glass ceramic cooking surface with 2 independently controlled 3.5 kW induction zones. Induction top surface with seamless transition between individual heating zones. Exterior panels in stainless steel with Scotch Brite finish. One piece pressed work top in 1.5 mm thick stainless steel. Right-angled side edges to allow flush-fitting junction between units.

  • 6mm glass ceramic cooking surface with 2 independently controlled induction zones with a power of 3.5 kW per zone.
  • Almost the entire surface of the ceramic plate can be used without “dead” spots.
  • Indicating lamp for each zone located on control console.
  • Induction plates endowed with overheating safety device.
  • Power to the individual zones can be set with progressive out put i.e. fine regulation at the lower and larger progress at the upper levels.
  • Low heat dissipation to the kitchen.
  • The smooth, glass ceramic plate is not directly heated, so there is no burning on cooking surface.
  • IPx4 water protection.
  • Pots diameter to be used : min 12cm, max 28 cm in order to obtain maximum heating efficiency.

  • All exterior panels in Stainless Steel with Scotch Brite finishing.
  • One piece pressed 1.5 mm work top in Stainless steel.
  • Model has right-angled side edges to allow flush fitting joints between units, eliminating gaps and possible dirt traps.
Electric
Supply voltage: 371131 (E7INED200N) 230 V/3 ph/50/60 Hz
Total Watts: 7 kW
Key Information:
Induction Top Dimensions (width): 400 mm
Induction Top Dimensions (depth): 730 mm
External dimensions, Width: 400 mm
External dimensions, Height: 250 mm
External dimensions, Depth: 730 mm
Net weight: 30 kg
Shipping weight: 39 kg
Shipping height: 371131 (E7INED200N) 540 mm
Shipping width: 460 mm
Shipping depth: 820 mm
Shipping volume: 0.2 m³
If appliance is set up or next to or against temperature sensitive furniture or similar, a safety gap of approximately 150 mm should be maintained or some form of heat insulation fitted. Induction compatible pots & pans must be used.
Certification group: 371131 (E7INED200N) NIN47F

Ficha técnica

CAD